FANUC ALM共70篇 第3页
This section mainly introduces the alarms and detailed descriptions of each FANUC system. Through this section, you can find common alarm solutions.
FANUC SP9006 THERMAL SENSOR DISCONNECT
FANUC SP9006 Reason for alarm An abnormality in the temperature sensor inside the spindle motor or a disconnection of the temperature sensor cable was detected. FANUC SP9006 troubl...
9天前FANUC SP9004 SSPA: 04 Power supply phase loss/fuse blown
FANUC SP9004 Reason for alarm Abnormal input power supply (abnormal power frequency, missing phase, unbalanced power supply). FANUC SP9004 troubleshooting Measure whether the m...
9天前FANUC SP9003 SSPA:03 DC LINK fuse blown
FANUC SP9003 Reason for alarm The fuse in the DC bus section has blown. (Insufficient voltage in the DC bus section) This alarm will be checked when the emergency stop is released....
10天前FANUC SP9002 SSPA:02 Speed deviation is too large
FANUC SP9002 Reason for alarm The spindle motor speed detection value deviates far from the command speed. FANUC SP9002 troubleshooting If this alarm is displayed during motor ac...
10天前FANUC SP9001 SSPA:01 Motor overheating
FANUC SP9001 Reason for alarm: It is detected that the internal temperature of the spindle motor exceeds the specified temperature. FANUC SP9001 troubleshooting When an alarm occur...
10天前Common FANUC CNC Alarms List
This FANUC alarm code list should help you properly diagnose your CNC error message. Fanuc Series 0i-Model A Maintenance Manual B-63505EN/02 What is a FANUC Alarm Code? A FANUC ala...
12天前FANUC system spindle SP9031 alarm solution
Today, a friend in the QQ CNC group encountered an alarm when the spindle rotated above 3000 rpm. It was normal when the spindle rotated below 3000 rpm. The picture of the alarm is...
13天前
Fanuc alarm: PS063 -THE BLOCK OF A SPECIFIED SEQUENCE NUMBER IS NOT FOUND
Fanuc alarm: PS063 -THE BLOCK OF A SPECIFIED SEQUENCE NUMBER IS NOT FOUND CNC Machine Control Manufacturer：Fanuc Control Model：, 16i/18i/21i, 0i-A 0i-B 0I-D 0I-F 0I-F PLUS Fanuc ...
28天前Fanuc alarm: PS062 -THE CUTTING AMOUNT IS ILLEGAL IN THE ROUGH CUTTING CYCLE
Fanuc alarm: PS062 -THE CUTTING AMOUNT IS ILLEGAL IN THE ROUGH CUTTING CYCLE CNC Machine Control Manufacturer：Fanuc Control Model：, 16i/18i/21i, 0i-A 0i-B 0I-D 0I-F 0I-F PLUS Fan...
28天前
