排序
FANUC SP9018 SUMCHECK ERROR PROGRAM ROM
Amplifier alarm number: 18 FANUC SP9018 Reason for the alarm: The spindle amplifier data ROM component is abnormal. Troubleshooting ideas:Replace the Spindle Amplifier (SP) control...
FANUC SP9017 Serial spindle alarm
Amplifier alarm number: 17 FANUC SP9017 Reason for the alarm: An abnormality in the spindle amplifier ID was detected. Troubleshooting ideas:Replace the spindle amplifier. FANUC SP...
FANUC SP9016 RAM ERROR
Amplifier alarm number: 16 FANUC SP9016 Reason for the alarm: The RAM used for external data in the spindle amplifier is abnormal. Troubleshooting ideas: The hardware is damaged, r...
FANUC SP9015 SPINDLE SWITCHING FAULT
Amplifier alarm number: 15 FANUC SP9015 Reason for the alarm: Caused by abnormal sequence during spindle switching/output switching. Troubleshooting ideas: 1) An alarm is issued wh...
FANUC SP9014 SOFTWARE SERIES MISMATCH
Amplifier alarm number: 14 FANUC SP9014Reason for the alarm: Using an amplifier that has not been logged in to the spindle software. Troubleshooting ideas: The spindle data was mis...
FANUC SP9013 CPU DATA MEMORY FAULT
Amplifier alarm number: 13 FANUC SP9013 Reason for the alarm: The spindle amplifier control circuit is abnormal. Troubleshooting ideas: Confirm that the hardware is damaged and rep...
FANUC SP9012 OVERCURRENT POWER CIRCUIT
Amplifier alarm number: 12 Reason for the alarm: Caused by excessive current in the spindle motor. FANUC SP9012 Troubleshooting ideas: 1) Check the initialization of the inherent p...
FANUC SP1220 spindleless amplifier
一、FANUC SP1220 Reason for alarm The cable connected to the serial spindle amplifier is disconnected, or the serial spindle amplifier has not been connected. 二、FANUC SP1220 trou...
FANUC SP9011 SSPA:11 DC LINK overvoltage
FANUC SP9011 Reason for alarm The voltage of the DC section (DC bus section) of the main circuit has increased abnormally. FANUC SP9011 troubleshooting This alarm occurs when the ...